The following is an overview of the user manual for the Z-Wave product Remote Temperature and Humidity Sensor (ZSENS930AW00MAA)from Nexia. To view other Z-Wave products and manuals from Nexia follow that link.
Overview
Security
As a Z-Wave Plus certified product, Remote Temperature and Humidity Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Nexia describes Remote Temperature and Humidity Sensor as having the following features:
- Battery powered using AAA batteries
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Sensors
- Battery Quantity
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Set your primary controller into inclusion mode. Press and release the ""Install"" button on the sensor. The ""Status"" LED will blink rapidly for 3 seconds indicating successful inclusion into the network.
Set your primary controller into exclusion mode. Press and release the ""Install"" button on the sensor. The ""Status"" LED will blink rapidly for 3 seconds indicating successful exclusion from the network.
A triple press of the ""Install"" button wakes the device up, and it will send a WAKE_UP_NOTIFICATION and a Battery Report (if on a network).
A single press of ""Install"" button will wake the device up, and it will send out a Node Information Frame.
Factory reset Remote Temperature and Humidity Sensor
Press and hold Install button for 10 seconds. Factory Reset should only be used if the primary controller is missing or inoperable.
Please note that this is a user manual Remote Temperature and Humidity Sensor from Nexia is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Remote Temperature and Humidity Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.