The following is an overview of the user manual for the Z-Wave product Dimmer-Control (FGD-212)from Nice. To view other Z-Wave products and manuals from Nice follow that link.
Overview
radio waves or through the wall switch connected directly to it.
New Dimmer-Control is equipped with an algorithm of smart light source detection which makes configuration easier and ensures high compatibility of the device. It may be used as a switch with non-dimmable light sources (in 3-wire connection).
Security
As a Z-Wave Plus certified product, Dimmer-Control supports Z-Wave S2 security. The following security modes are directly supported:
Features
Nice describes Dimmer-Control as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Dimmer-Control
1. Disconnect the power supply.
2. Remove Dimmer-Control from the wall switch box.
3. Connect the power supply.
4. Locate the B-button on the housing.
5. Press and hold the B-button to enter the menu mode.
6. Wait for the visual LED indicator to turn yellow.
7. Quickly release and click the B-button again.
8. After few seconds the device will be restarted, which is signalled with the red LED indicator colour.
9. The device enters the calibration mode.
1. Place Dimmer-Control within the direct range of your Z-Wave controller.
2. Identify switch no. 1 (turns the light on) or the B-button (located on the device’s housing).
3. Set the main controller in remove mode (see the controller’s manual).
4. Quickly, three times press switch no. 1 or the B-button.
5. Wait for the removing process to end.
6. Successful removing will be confirmed by the Z-Wave controller’s message.
7. Dimmer-Control will start the calibration process.
To add the device to the Z-Wave network manually:
1. Place Dimmer-Control within the direct range of your Z-Wave controller.
2. Identify switch no. 1 (turns the light on) or the B-button (located on the device’s housing).
3. Set the main controller in (security/non-security) add mode (see the controller’s manual).
4. Quickly, three times press switch no. 1 or the B-button.
5. Wait for the adding process to end.
6. Successful adding will be confirmed by the Z-Wave controller’s message.
Please note that this is a user manual Dimmer-Control from Nice is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Dimmer-Control and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.