The following is an overview of the user manual for the Z-Wave product Door/Window-Control (FGDW-002)from Nice. To view other Z-Wave products and manuals from Nice follow that link.
Overview
Sensor can be used to trigger scenes and wherever there is a need for information about opening or closing of doors, windows, garage doors, etc. Opening is detected by separating the sensor’s body and the magnet.In addition, Door/Window-Control is equipped with a built-in temperature sensor.
Security
As a Z-Wave Plus certified product, Door/Window-Control supports Z-Wave S2 security. The following security modes are directly supported:
Features
Nice describes Door/Window-Control as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Door/Window-Control needs to be woken up to receive information about the new configuration from the controller, like parameters and associations.
To wake up the sensor manually, click one of the TMP buttons (while the other button is pressed).
To remove the device from the Z-Wave network:
1. Place Door/Window-Control within the direct range of your Z-Wave controller.
2. Set the main controller into remove mode (see the controller’s manual).
3. Quickly, three times press one of the TMP buttons (while the other button is pressed).
4. Wait for the removing process to end.
5. Successful removing will be confirmed by the Z-Wave controller’s message.
To add the device to the Z-Wave network manually:
1. Place Door/Window-Control within the direct range of your Z-Wave controller.
2. Set the main controller in (Security/non-Security Mode) add mode (see the controller’s manual).
3. Quickly, three times press one of the TMP buttons (while the other button is pressed).
4. Wait for the adding process to end.
5. Successful adding will be confirmed by the Z-Wave controller’s message.
Factory reset Door/Window-Control
Reset procedure allows to restore the device back to its factory settings, which means all information about the Z-Wave controller and user
configuration will be deleted.
In order to reset the device:
1. Open the cover (Opening the casing may result in triggering an alarm. To avoid it, remove the associations for the 3rd group).
2. Remove the battery.
3. Install the battery while holding both TMP buttons.
4. Visual LED indicator will be flashing slowly for 5 seconds - keep holding the buttons.
5. Release one button when the LED indicator starts flashing quickly.
6. Click released button once to confirm launching of reset procedure.
7. Wait a few seconds until a long blink of the LED indicator. Do not remove the battery.
8. Visual LED indicator will blink 5 times quickly to confirm the reset.
Please note that this is a user manual Door/Window-Control from Nice is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door/Window-Control and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.