The following is an overview of the user manual for the Z-Wave product Flood-Control (FGFS-101)from Nice. To view other Z-Wave products and manuals from Nice follow that link.
Overview
The device has built in temperature sensor that allows to monitor ambient temperature. Flood-Control is designed to be placed on the floor or mounted on a wall (in this case Flood-Control probes should be extended using addition wire). The device has a built-in visual LED indicator and an acoustic alarm.
In addition, the sensor is equipped with a tilt sensor reporting tilt or movement to the main controller e.g. when someone has taken the Sensor from its original location.
Flood-Control is sink-proof, which means it drifts on the water surface and keeps on sending alarm signal in case of substantial inundation of
water.
Security
As a Z-Wave Plus certified product, Flood-Control supports Z-Wave S2 security. The following security modes are directly supported:
Features
Nice describes Flood-Control as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To remove the device from the Z-Wave network:
1. Open the cover.
2. Place the Sensor within the direct range of your Z-Wave controller.
3. Set the main controller into remove mode (see the controller’s manual).
4. Quickly, three times press the TMP button.
5. Wait for the removing process to end.
6. Successful removing will be confirmed by the Z-Wave controller’s message.
Waking up the Flood-Control
When in battery mode the Flood-Control needs to be woken up to receive information about the new configuration from the controller, like
parameters and associations.
To wake up the sensor manually, click the TMP button located inside the housing.
The device will also wake up and update its data upon startup when added in battery mode.
Factory reset Flood-Control
Reset procedure allows to restore the device back to its factory settings, which means all information about the Z-Wave controller and user
configuration will be deleted.
1. Make sure the sensor is powered.
2. Press and hold the TMP button.
3. Wait for the visual LED indicator to glow yellow (4th position of the MENU).
4. Release the TMP button.
5. Click the TMP button once to confirm selection.
6. After few seconds the device will restart with factory settings, which is signalled with the red visual indicator colour and
7. an acoustic signal.
Adding (Inclusion) - Z-Wave device learning mode, allowing to add the device to existing Z-Wave network.
To add the device to the Z-Wave network manually:
1. Open the cover.
2. Place the Sensor within the direct range of your Z-Wave controller.
3. Set the main controller in (security/non-security) add mode (see the controller’s manual).
4. Quickly, three times press the TMP button.
5. Wait for the adding process to end.
6. Successful adding will be confirmed by the Z-Wave controller’s message.
Please note that this is a user manual Flood-Control from Nice is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Flood-Control and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.