The following is an overview of the user manual for the Z-Wave product Motion-Control (FGMS-001)from Nice. To view other Z-Wave products and manuals from Nice follow that link.
Overview
Motion-Control is a battery-powered device designed to be installed quickly and easily on any surface. The LED indicator signals motion, temperature level, operating mode and can indicate if the device is within the Z-Wave network.
The device can be used for lighting scenes and presence monitoring systems.
Security
As a Z-Wave Plus certified product, Motion-Control supports Z-Wave S2 security. The following security modes are directly supported:
Features
Nice describes Motion-Control as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Open the cover.
2. Place the Motion-Control within the direct range of your Z-Wave controller.
3. Set the main controller in remove mode (see the controller’s manual).
4. Quickly, three times press the B-button.
5. Wait for the removing process to end.
6. Successful removing will be confirmed by the Z-Wave controller’s message.
1x click: wake up the device or select the desired menu option (if menu is active)
Factory reset Motion-Control
Resetting the Motion-Control
Reset procedure erases the memory, including all information on the Z-Wave network and the main controller.
1. Open the cover.
2. Press and hold the B-button.
3. Wait for visual indicator to glow yellow (2nd menu position).
4. Release the B-button.
5. Click the B-button to confirm selection.
6. After few seconds the device will be reset, which is signalled with the red, fading visual indicator colour.
To add the device to the Z-Wave network manually:
1. Open the cover.
2. Place the Motion-Control within the direct range of your Z-Wave controller.
3. Set the main controller in (security/non-security) add mode (see the controller’s manual).
4. Quickly, three times press the B-button.
5. Wait for the adding process to end.
6. Successful adding will be confirmed by the Z-Wave controller’s message
Please note that this is a user manual Motion-Control from Nice is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Motion-Control and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.