The following is an overview of the user manual for the Z-Wave product On/Off-Control (FGS-223)from Nice. To view other Z-Wave products and manuals from Nice follow that link.
Overview
On/Off-Control allows to control connected devices either via the Z-Wave Plus network or via a switch connected directly to it and is
equipped with active power and energy consumption metering functionality
Security
As a Z-Wave Plus certified product, On/Off-Control supports Z-Wave S2 security. The following security modes are directly supported:
Features
Nice describes On/Off-Control as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To remove the device from the Z-Wave network:
1. Place On/Off-Control within the direct range of your Z-Wave controller.
2. Identify the S1 switch.
3. Set the main controller in remove mode (see the controller’s manual).
4. Quickly, three times press the S1 switch.
5. Wait for the removing process to end.
6. Successful removing will be confirmed by the Z-Wave controller’s message.
Factory reset On/Off-Control
Resetting On/Off-Control
1. Switch off the mains voltage (disable the fuse).
2. Remove On/Off-Control from the wall switch box.
3. Switch on the mains voltage.
4. Press and hold the B-button to enter the menu.
5. Wait for the visual LED indicator to glow yellow.
6. Quickly release and click the B-button again.
7. After few seconds the device will be restarted, which is signalled with the red LED indicator colour
To add the device to the Z-Wave network manually:
1. Place On/Off-Control within the direct range of your Z-Wave controller.
2. Identify the S1 switch.
3. Set the main controller in (security/non-security) add mode (see the controller’s manual).
4. Quickly, three times press the S1 switch.
5. Wait for the adding process to end.
6. Successful adding will be confirmed by the Z-Wave controller’s message.
Please note that this is a user manual On/Off-Control from Nice is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have On/Off-Control and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.