The following is an overview of the user manual for the Z-Wave product Push-Control (FGPB-101)from Nice. To view other Z-Wave products and manuals from Nice follow that link.
Overview
Different actions may be triggered with one to five clicks or by holding the button down. In panic mode, each press of the button results in triggering the alarm defined in the Z-Wave controller.
Due to its small design and wireless communication, Push-Control can be conveniently mounted on any surface and in any position or location at home, e.g. beside the bed or under the desk.
Security
As a Z-Wave Plus certified product, Push-Control supports Z-Wave S2 security. The following security modes are directly supported:
Features
Nice describes Push-Control as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To add the device to the Z-Wave network manually:
1. Place Push-Control within the direct range of your Z-Wave controller.
2. Set the main controller in (Security/non-Security) add mode (see the controller’s manual).
3. Click Push-Control at least six times.
4. Wait for the adding process to end.
5. Successful adding will be confirmed by the Z-Wave controller’s message.
To remove the device from the Z-Wave network:
1. Place Push-Control within the direct range of your Z-Wave controller.
2. Set the main controller in remove mode (see the controller’s manual).
3. Click Push-Control at least six times.
4. Wait for the removing process to end.
5. Successful removing will be confirmed by the Z-Wave controller’s message.
6.2 - Waking up the device
Push-Control needs to be woken up to receive information about the new configuration from the controller, like parameters and associations.
Click Push-Control 4 times to wake it up.
Factory reset Push-Control
6.4 - Reset procedure of Push-Control
Reset procedure allows to restore the device back to its factory settings, which means all information about the Z-Wave controller and user configuration will be deleted. In order to reset the device:
1. Click Push-Control exactly five times.
2. Press and hold Push-Control for at least 5 seconds.
Please note that this is a user manual Push-Control from Nice is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Push-Control and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.