The following is an overview of the user manual for the Z-Wave product Z-Wave+ Smart Plug ON/OFF (Type E) (ASP-3-1-00)from NodOn. To view other Z-Wave products and manuals from NodOn follow that link.
Overview
In both standard, Type E (French) or Schuko (German), the plug can be mounted in both side (head up or head down). Combined to its ultra-thin design, these both specificities allow an easy integration, without obstructing nearby power holes on a power strip.
Equipped with a very small super-capacitor, the NodOn Smart Plug is able to send an emergency frame to the gateway in case of power outage.
The NodOn Smart Plug is based on brand new 500 series Z-Wave® module from Sigma Designs®, and support all the new features of Z-Wave Plus® standard:
Longer range (up to 40m), lower power consumption, higher data rate transmission, and many more new features.
Security
As a Z-Wave Plus certified product, Z-Wave+ Smart Plug ON/OFF (Type E) supports Z-Wave S2 security. The following security modes are directly supported:
Features
NodOn describes Z-Wave+ Smart Plug ON/OFF (Type E) as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Long press during 2 seconds to send several NIF during 30 seconds or a triple press to send a single NIF
Long press during 2 seconds to send several NIF during 30 seconds or a triple press to send a single NIF
Factory reset Z-Wave+ Smart Plug ON/OFF (Type E)
Long press during more than 5 seconds then release.
Please use this procedure only when the primary controller is missing or otherwise inoperable.
Power outage / Power recover detection: The product is equipped with a small super-capacitor, allow to send an emergency frame in case of power outage
Alarm priority management (check user guide for full details)
Please note that this is a user manual Z-Wave+ Smart Plug ON/OFF (Type E) from NodOn is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave+ Smart Plug ON/OFF (Type E) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.