The following is an overview of the user manual for the Z-Wave product StickZ (HUSBZ-1)from Nortek. To view other Z-Wave products and manuals from Nortek follow that link.
Overview
Security
As a Z-Wave Plus certified product, StickZ supports Z-Wave S2 security. The following security modes are directly supported:
Features
Nortek describes StickZ as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Controlled by the host device the HUSBZ-1 is connected to.
Controlled by the host device the HUSBZ-1 is connected to.
Controlled by the host device the HUSBZ-1 is connected to.
Factory reset StickZ
Not Applicable.
Please note that this is a user manual StickZ from Nortek is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have StickZ and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.