The following is an overview of the user manual for the Z-Wave product NortheastGas Association Wireless Methane Gas Detector (TFW-01)from Northeast Gas Association. To view other Z-Wave products and manuals from Northeast Gas Association follow that link.
Overview
Security
As a Z-Wave Plus certified product, NortheastGas Association Wireless Methane Gas Detector supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Northeast Gas Association describes NortheastGas Association Wireless Methane Gas Detector as having the following features:
- Communications Protocol
- Battery Quantity
- Sensors
- Battery powered using 9-volt batteries
- Supported Notification Types
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset NortheastGas Association Wireless Methane Gas Detector
• This device will perform a Z-Wave factory reset when the exclusion process stated above is followed. Please use this procedure only when the network primary controller is missing or otherwise inoperable
• To remove the unit from a network put the controller (purchased separately) into the pairing/removal/exclusion mode and then press and hold the inclusion/exclusion button on the side of the detector for at least 5 seconds. The blue light will begin to flash and will go out when the device is removed from the network
• To add the unit to the network, put the controller (purchased separately) into the pairing/add/inclusion mode and then press and hold the inclusion/exclusion button on the side of the detector for at least 5 seconds. The blue light will begin to flash to indicate it’s in the pairing mode. When the blue light goes solid, the unit has been included in the network. If the blue light is not illuminated, the unit is not part of a network
Please note that this is a user manual NortheastGas Association Wireless Methane Gas Detector from Northeast Gas Association is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have NortheastGas Association Wireless Methane Gas Detector and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.