The following is an overview of the user manual for the Z-Wave product Premium Controller (NHUB200)from NuTone. To view other Z-Wave products and manuals from NuTone follow that link.
Overview
Security
As a Z-Wave Plus certified product, Premium Controller supports Z-Wave S2 security. The following security modes are directly supported:
Features
NuTone describes Premium Controller as having the following features:
- Color
- Communications Connections
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To include the controller into an existing Z-Wave network, use the UI and follow the steps below.
Click on Settings -> Z-Wave Settings -> Advanced, select 'Copy Z-Wave network from a primary controller. This will shift the controller to have a secondary controller role and will receive data from the primary controller in the network.
Factory reset Premium Controller
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
To reset the controller, press the reset button for 6 times in 6 seconds. This will reset it to factory default.
To exclude a Z-Wave product into the network, you can use the UI and follow the on- screen instructions that read as follows:
Navigate to the device -> Select the delete device option -> Choose to un-pair and follow the instructions. [Attached images along with the manual].
For an installer who wishes to manually exclude a Z-Wave product from the network, Press the Select button 2 times and then press and hold the Sync button down for 3 seconds.
To include a Z-Wave product into the network, you can use the UI and follow the on- screen instructions that read as follows:
Select Add device -> Pick the device to be included in the network from the list -> Follow the steps for inclusion of the device -> Once the device is detected, save the name of the device and the device completes the configuration process. [Attached images along with the manual]. For an installer who wishes to carry out a manual setup of devices, tap the Select button 2 times and then press the Sync button on the controller. To exit the inclusion mode on the controller, press and hold the Select button for 6 seconds.
Please note that this is a user manual Premium Controller from NuTone is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Premium Controller and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.