The following is an overview of the user manual for the Z-Wave product Smart Plug (PSC234ZW)from permundo. To view other Z-Wave products and manuals from permundo follow that link.
Overview
The PSC234ZW has a built-in safety features that will switch-off the output in case of too high temperature or overload.
Additionally the PSC234 has a feature to switch the load on at zero voltage and switch the load off at zero current. This leads to a very high number of possible switching cycles also for difficult loads like led-lamps or motors, e.g. pumps.
Security
As a Z-Wave Plus certified product, Smart Plug supports Z-Wave S2 security. The following security modes are directly supported:
Features
permundo describes Smart Plug as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Smart Plug
Please use this procedure only if the primary controller is missing or inoperable:
The device can be put into factory default state manually by the following procedure:
1) hold the touch-button until the led
shows red light
2) release the touch-button and hold the
touch-button again until the led starts
to flash green
The PSC234 confirms the successful completion of the factory reset procedure by steady red flashing.
When a PSC234 that is not associated to a Z-Wave network, is inserted into the mains outlet, it will flash once red followed by 2 green flashed followed by steady red flashing. The PSC234 can now be added to (=inclusion) or removed from (=exclusion) a Z-Wave network:
1) start inclusion/exclusion on the primary
controller
2) hold the touch button until the led
shows green light
3) release the touch button
The PSC234 will confirm successful removal/exclusion by steady red flashing. At the time of exclusion the device is factory reset.
When a PSC234 that is not associated to a Z-Wave Network, is inserted into the mains outlet, it will flash once red followed by 2 green flashed followed by steady red flashing. The PSC234 can now be added to (=inclusion) or removed from (=exclusion) a Z-Wave network:
1) start inclusion/exclusion on the primary
controller
2) hold the touch button until the led
shows green light
3) release the touch button
The PSC234 will confirm successful addition to the network by 5 green flashes.
The PSC234 will confirm successful removal/exclusion by steady red flashing. At the time of exclusion the device is factory reset.
Please note that this is a user manual Smart Plug from permundo is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Plug and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.