The following is an overview of the user manual for the Z-Wave product 2 Wire Dimmer (PAD15-ANZ)from Philio. To view other Z-Wave products and manuals from Philio follow that link.
Overview
install.
This device is a security enabled Z-Wave Plus™ product that
uses encrypted Z-Wave Plus™ messages to communicate to
other security enabled Z-Wave Plus™ products. Z-Wave™
enabled devices displaying the Z-Wave™ logo can also be used
with this device regardless of the manufacturer, and this device
can also be used in other manufacturer’s Z-Wave™ enabled
networks.
Security
As a Z-Wave Plus certified product, 2 Wire Dimmer supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Philio describes 2 Wire Dimmer as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: 1. The product has a DSK string. Key in the first five digits to initiate the SmartStart process, or scan QR code.
Ex: DSK: 18112-24021- 48001-62259-57092-27453-08187-47408
2. SmartStart enabled products can be added into a Z-Wave™ network by scanning the Z-Wave™ QR
Code on the product, with a controller providing SmartStart inclusion. No further action is required and the SmartStart product will be added automatically to the closest network within 10 minutes of being switched on.
Notice:
The QR Code can be foundon the device PAD15 or in the box.
Add(Classic Inclusion) : 1. Put your Z-Wave™ controller into inclusion mode by following the instructions
provided by the controller manufacturer. 2. Press the include button three times within 3 seconds to enter
inclusion mode.
Remove (Exclusion) 1. Put your Z-Wave™ controller into exclusion mode by following the instructions
provided by the controller manufacturer. 2. Press the include button three times within 3 seconds to enter
exclusion mode. 3. Node ID will be excluded.
Factory reset 2 Wire Dimmer
Reset : 1. Press the include button four times within 3 seconds and hold on the button press without
releasing. 2. Keep pressing the button for 3 seconds then LED will be o ,release the button within 2 seconds.
3. Device has been reset. ※Function Reset : Please use this procedure only when the network primary
controller is missing or otherwise inoperable.
Please note that this is a user manual 2 Wire Dimmer from Philio is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 2 Wire Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.