The following is an overview of the user manual for the Z-Wave product 4 in 1 Multi-Sensor (PST10)from Philio. To view other Z-Wave products and manuals from Philio follow that link.
Overview
Security
As a Z-Wave Plus certified product, 4 in 1 Multi-Sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Philio describes 4 in 1 Multi-Sensor as having the following features:
- Battery powered using CR123A batteries
- Color
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: 1. Product has a DSK string, you can key in first five digit to increment smart start process, or you can scan QR code.
2. SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR Code present on the product with a control
1. Have Z-WaveTM Controller entered inclusion mode.
2. Pressing tamper key three times within 2 seconds to enter the inclusion mode.
3. After add successful, the device will wake to receive the setting command from Z-WaveTM Controller about 20 seconds.
1. Have Z-WaveTM Controller entered exclusion mode.
2. Pressing tamper key three times within 2 seconds to enter the exclusion mode.
Node ID has been excluded.
After the device adding to the network, it will wake-up once per day in default. When it wake-up it will broadcast the “Wake Up Notification” message to the network, and wake-up 10 seconds for receive the setting commands.
The wake-up interval minimum se
Factory reset 4 in 1 Multi-Sensor
Notice: Use this procedure only in the event that the primary controller is lost or otherwise inoperable.
1. Pressing button four times and keep about 5 seconds.
2. IDs are excluded and all settings will reset to factory default.
Please note that this is a user manual 4 in 1 Multi-Sensor from Philio is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 4 in 1 Multi-Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.