The following is an overview of the user manual for the Z-Wave product Air Quality Multi Sensor (PAT05)from Philio Technology. To view other Z-Wave products and manuals from Philio follow that link.
Overview
This device is a security enabled Z-Wave Plus product that is able to use encrypted Z-Wave Plus messages to communicate to other security enabled Z-Wave Plus products. Z-WaveTM enabled devices displaying the Z-WaveTM logo can also be used with it regardless of the manufacturer, and ours can also be used in other manufacturer’s Z-WaveTM enabled networks.
The product supports Over The Air(OTA) feature for the products firmware upgrade.
This product can be included and operated in any Z-WaveTM network with other Z-WaveTM certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
The device adopt the Z-WaveTM 500 series chip, when your Z-WaveTM network system is all made by Z-WaveTM 500 series devices. The network system will have the advantages as below.
Security
As a Z-Wave Plus certified product, Air Quality Multi Sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Philio describes Air Quality Multi Sensor as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Have Z-WaveTM Controller entered inclusion mode.
2. Pressing tamper key three times within 2 seconds to enter the inclusion mode.
1. Have Z-WaveTM Controller entered exclusion mode.
2. Pressing tamper key three times within 2 seconds to enter the exclusion mode.
3. Node ID has been excluded.
Factory reset Air Quality Multi Sensor
1. Pressing Include button of PAT05 three times within 2 seconds will enter inclusion mode.
2. Within 1 second, press Include button of PAT05 again for 5 seconds.
3. Node ID has been reset excluded.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
SmartStart location
SmartStart QR code's location as follows: The DSK can be found on the front of your product.
Please note that this is a user manual Air Quality Multi Sensor from Philio Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Air Quality Multi Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.