Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

CO2 Sensor-A (PAT12) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product CO2 Sensor-A (PAT12)from Philio. To view other Z-Wave products and manuals from Philio follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
CO2 Sensor-A
SKU Code
PAT12
Description
The PAT12 sensor is easy to use and very convenient for your home. Just set the sensor on the wall in the rooms you would like to control, and you are ready to go. Moreover, the PAT12 can be integrated to other Z-Wave certified devices, and controlled with Philio app “Home Mate 2.” You can now protect your family and your business and make sure that air you are breathing is safe. Set up your PAT12 to send regular notifications and take control even when not at home.
Version #
HW: 1 FW: 1.02:01.02 was the version certified
Certification #
ZC10-19096749
Certified
2019-09-12T15:57:33.812051
Z-Wave Version
6.81.03

Security

As a Z-Wave Plus certified product, CO2 Sensor-A supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

Philio describes CO2 Sensor-A as having the following features:

  • Firmware updatable via a compatible Z-Wave gateway
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

SmartStart location

SmartStart QR code's location as follows: The QR code can befoundon the device PAT12 or in the box.

1. Set your Z-Wave controller into inclusion mode by following the instructions provided by the controller manufacturer.
2. Press the include button of the PAT12 three times within 3 seconds to enter inclusion mode.

1. Set your Z-Wave controller into exclusion mode by following the instructions provided by the controller manufacturer.
2. Press the include button of the PAT12 three times within 3 seconds to enter exclusion mode.
3. Node ID has been excluded.

Factory reset CO2 Sensor-A

1. Press the include button of the PAT12 three times within 3 seconds to enter inclusion mode.
2. Within 1 second, again press the include button of the PAT12 for 5 seconds.
3. IDs will get excluded.
notice1:Please use this procedure only when the network primary controller is missing or otherwise inoperable.

Please note that this is a user manual CO2 Sensor-A from Philio is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have CO2 Sensor-A and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.