The following is an overview of the user manual for the Z-Wave product Control Center Gateway (PSC03)from Philio Technology. To view other Z-Wave products and manuals from Philio follow that link.
Overview
Security
As a Z-Wave Plus certified product, Control Center Gateway supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
Philio describes Control Center Gateway as having the following features:
- Communications Connections
- Firmware updatable via a compatible Z-Wave gateway
- Supported Notification Types
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
The primary controller can exclude devices from the Z-Wave network. During exclude the relationship between the device and the controller. No communication could happen after successful exclusion, between the device and other devices in the original network.
Please click ""Exclude"".
It will show count down time, and gateway will be in exclusion mode, include/exclude led will start flash in fast mode. Please send ""Node Info"" from device before count down time end.
If success, it will show device which was added in gateway on screen, but if device wasn't added into gateway before, it will show nothing on screen.
(Please check your user document, the detail in 3.1)
Factory reset Control Center Gateway
Reset the Z-Wave controller. It will reset the Z-Wave controller and will be assign a new Z-Wave home id.
Please click ""Reset Gateway"", it will show ""Reset"" message
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
(Please check your user document, the detail in 3.1.3)
Communication between two Z-Wave devices only works if both belong to the same wireless network. Joining a network is called inclusion and is initiated by a controller. The controller needs to be turned into the inclusion mode.
Please click ""Include"", it will show ""Include"" message.
(Please check your user document, the detail in 3.1)
The gateway can join another Z-Wave network and will be a slave device. If the gateway is included in other network, it can receive (replication) the latest network information from SUC again.
But the gateway can’t use this function if the gateway is the SIS and others nodes are included in the network
Please click ""Learn"". It will show learn message (the count down time and the gateway’s DSK).
(Please check your user document, the detail in 3.1.4)
Please note that this is a user manual Control Center Gateway from Philio Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Control Center Gateway and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.