The following is an overview of the user manual for the Z-Wave product DoorLock (PSA03-US)from Philio Technology. To view other Z-Wave products and manuals from Philio follow that link.
Overview
Security
As a Z-Wave Plus certified product, DoorLock supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Philio describes DoorLock as having the following features:
- Door Lock Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1.check Z-WaveTM Controller entered inclusion mode.
2.Press the Add/Remove function
“enterPC” is enter “0000”(default)
enterPC->enter-> 1 -> 0 ->enter
3.After add successful, it will have twice beep sounds.if inclusion fail it will have five beep.
Notice 1 : if you reset doorlock ,you have to do OPERATING INSTRUCTION no.1(door handling identification process )
Notice 2:if Door lock in learn mode,device can stop on operation setting mode,until success include or 60s time out.
1.check Z-WaveTM Controller entered exclusion mode.
2.Press the Add/Remove function
“enterPC” is enter “0000”(default)
enterPC->enter-> 1 -> 0 ->enter
3.After remove successful, it will have twice beep sounds.if exclusion fail it will have five beep.
Notice 1 : if you reset doorlock ,you have to do OPERATING INSTRUCTION no.1(door handling identification process )
Notice 2:if Door lock in learn mode,device can stop on operation setting mode,until success include or 60s time out.
Factory reset DoorLock
1.Press the black key in battery cover, and until 5s time up.device can beep two times.
2.Device can send resetlocally notification
note : Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual DoorLock from Philio Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have DoorLock and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.