The following is an overview of the user manual for the Z-Wave product In Wall Dual relay(1 way) switch module (PAN04-1A)from Philio. To view other Z-Wave products and manuals from Philio follow that link.
Overview
application by using the module to switch AC power On and Off, one main application is the light control. The new smart relay calibration technology can reduce the inrush current caused by the load and let the module work perfectly with many kind of light like incandescent, fluorescent and LED light.
This in-wall switch module is able to detect Instant power wattage and overload current (7.5A) of connected light or appliances. When detecting overload state, the Module will be disabled and its On/Off button will be lockout of which LED will flash quickly. However, disconnect and re-connect the Module will reset its overload condition to normal status.
Security
As a Z-Wave Plus certified product, In Wall Dual relay(1 way) switch module supports Z-Wave S2 security. The following security modes are directly supported:
Features
Philio describes In Wall Dual relay(1 way) switch module as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Put your Z-Wave controller into inclusion mode by following the instructions provided by the controller manufacturer.
2. Pressing INCLUDE_BUTTON three times within 2 seconds will enter inclusion mode.
1. Put your Z-Wave controller into exclusion mode by following the instructions provided by the controller manufacturer.
2. Pressing INCLUDE_BUTTON three times within 2 seconds will enter exclusion mode.
Factory reset In Wall Dual relay(1 way) switch module
This procedure should only be used in the event the primary controller is lost or otherwise inoperable.
1. Pressing INCLUDE_BUTTON three times within 2 seconds will enter inclusion mode.
2. Within 1 second, press INCLUDE_BUTTON again for 5 seconds.
3. IDs are excluded.
Please note that this is a user manual In Wall Dual relay(1 way) switch module from Philio is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In Wall Dual relay(1 way) switch module and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.