The following is an overview of the user manual for the Z-Wave product In Wall Single relay (1 way) switch module (PAN05-1A)from Philio. To view other Z-Wave products and manuals from Philio follow that link.
Overview
There are many kind of application by using the module to switch Load On and Off, one main application is the light control. If connect the COM terminal directly to AC Line terminal, the new smart relay calibration technology can reduce the inrush current caused by the load and let the module work perfectly with many kind of light like incandescent, fluorescent and LED light. This module can also connect to alternative power supply like DC 12V to switch on/off 12V MR-16 light.
Security
As a Z-Wave Plus certified product, In Wall Single relay (1 way) switch module supports Z-Wave S2 security. The following security modes are directly supported:
Features
Philio describes In Wall Single relay (1 way) switch module as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Put your Z-Wave controller into inclusion mode by following the instructions provided by the controller manufacturer.
2. Pressing Include button of PAN05 three times within 2 seconds will enter inclusion mode.
1. Put your Z-Wave controller into exclusion mode by following the instructions provided by the controller manufacturer.
2. Pressing Include button of PAN05 three times within 2 seconds will enter inclusion mode.
Factory reset In Wall Single relay (1 way) switch module
This procedure should only be used in the event that the primary controller is lost or otherwise inoperable.
1. Pressing Include button of PAN05 three times within 2 seconds will enter inclusion mode.
2. Within 1 second, press Include button of PAN05 again for 5 seconds.
3. IDs are excluded.
Please note that this is a user manual In Wall Single relay (1 way) switch module from Philio is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In Wall Single relay (1 way) switch module and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.