The following is an overview of the user manual for the Z-Wave product Remote (PSR03)from Philio. To view other Z-Wave products and manuals from Philio follow that link.
Overview
It is a Z-Wave™ plus product, it supports the security, OTA... Those newest features of the Z-Wave™ technology. Z-Wave™ is a wireless communication protocol designed for home automation, specifically to remotely control applications in residential and light commercial environments. The technology uses a low-power RF radio embedded or retrofitted into home electronics devices and systems, such as lighting, home access control, entertainment systems and household appliances.
Security
As a Z-Wave Plus certified product, Remote supports Z-Wave S2 security. The following security modes are directly supported:
Features
Philio describes Remote as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Remote
Notice: Use this procedure only in the event that the primary controller is lost or otherwise inoperable.
1. Hold down the central key, then press the top-right key four times within 1.5 seconds and do not release the top-right key in the 4 th pressed, and the LED will light ON.
2. After 3 seconds the LED will turn OFF, after that within 2 seconds, release the keys. If successful, the LED will light ON one second. Otherwise, the LED will flash once.
3. IDs are remove and all settings will reset to factory
default.
1. Have Z-Wave TM Controller entered add mode.
2. Hold down the central key, then press the top-right key three times within 1.5 seconds to enter the add mode.
3. After add successful, the device will wake to receive the setting command from Z-Wave ™ Controller about 20 seconds.
1. Have Z-Wave ™ Controller entered remove mode.
2. Hold down the central key, then press the top-right
key three times within 1.5 seconds to enter the
remove mode.
Node ID has been excluded.
After the device adding to the network, it will wake-up once per day in default. When it wake-up it will broadcast the “Wake Up Notification” message to the network, and wake-up 10 seconds for receive the setting commands. The wake-up interval minimum setting is 30 minutes, and maximum setting is 120 hours. And the interval step is 30 minutes. If the user want to wake-up the device immediately, please press the button once. The device will wake-up 10 seconds.
Please note that this is a user manual Remote from Philio is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Remote and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.