Single Function PIR Sensor (PSP05) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Single Function PIR Sensor (PSP05)from Philio. To view other Z-Wave products and manuals from Philio follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Single Function PIR Sensor
SKU Code
PSP05
Description
The PIR sensor PSP05 has PIR sensor function,based on Z-Wave™ technology.
Version #
HW: 1 FW: 1.27:01.21 was the version certified
Certification #
ZC10-16105258
Certified
2016-10-06T11:29:35.3912
Z-Wave Version
6.51.09

Security

As a Z-Wave Plus certified product, Single Function PIR Sensor supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Philio describes Single Function PIR Sensor as having the following features:

    • Color
    • Battery Quantity
    • Battery powered using CR123A batteries
    • Sensors
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Factory reset Single Function PIR Sensor

    There is a button on PSP05.
    1. Pressing button for about 5 seconds.
    2. IDs are excluded and all settings will reset to factory default.
    Notice: Use this procedure only in the event that the primary controller is lost or otherwise inoperable.

    There is a button on PSP05.
    Press the button once, the device will awake 10 seconds.

    There is a button on PSP05.
    1. Have Z-Wave™ Controller entered inclusion mode.
    2. Pressing button once to enter the inclusion mode.
    3. After add successful, the device will wake to receive the setting command from Z-Wave™ Controller about 20 seconds.

    There is a button on PSP05.
    1. Have Z-Wave™ Controller entered exclusion mode.
    2. Pressing button once to enter the exclusion mode.

    Please note that this is a user manual Single Function PIR Sensor from Philio is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Single Function PIR Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.