The following is an overview of the user manual for the Z-Wave product Smart Dimmer Plug (PAD09-4)from Philio Technology. To view other Z-Wave products and manuals from Philio follow that link.
Overview
lighting in your house. The unit also provides dimmer function which is only applicable to light bulbs. At 220-240V voltage, this Dimmer Plug can support connected load of Max. 200W. To manually switch on the light, press and release the On/Off dimmer button when the light is off. The light will dim from off to the level which was set before switch off. To manually switch off the light, press and release the On/Off button shortly when the
light is on. To adjust the dim level, press and hold the On/Off button until the desired dim level is achieved, then release.
Security
As a Z-Wave Plus certified product, Smart Dimmer Plug supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Philio describes Smart Dimmer Plug as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Smart Dimmer Plug
1. Pressing Include button of PAD09 three times within 2 seconds will enter inclusion mode.
2. Within 1 second, press Include button of PAD09 again for 5 seconds.
3. IDs are excluded.
note : Please use this procedure only when the network primary controller is missing or otherwise inoperable.
1.check Z-WaveTM Controller entered inclusion mode.
2.Pressing Include button of PAD09 three times within 2 seconds will
enter inclusion mode.
1.check Z-WaveTM Controller entered exclusion mode.
2.Pressing Include button of PAD09 three times within 2 seconds will
enter exclusion mode.
The Switch can be set to send reports to associated Z-Wave devices. It supportsOne association group with five nodes support for grouping.
Grouping 1 Lifeline(Maximum 5 nodes):When “on” or “off ” state has been changed, it will send Multilevel Switch Report to the nodes of Grouping 1.
Grouping 2 Control_Key1 : (Maximum 5 nodes):When the On/Off status changes or the dim level is achieved manually, it will send
BASIC_SET command to group 2 nodes to make them unanimous.
When PAD09 detects the Overload, it will send Notification Report to Group 1 nodes. After detecting overload state and sending this Notification report, PAD09 will turn off
the dimmer automatically and lockout the On/Off button. The only thing to do is unplug PAD09 and reduce the load. Then re-power on PAD09 and it will work again.
The content of Notification Report
Notification report command: [Command_Class_Notification, Notification_Report, Notification Status= 0xFF, Notification Type = 0x08, Event = 0x08]
Please note that this is a user manual Smart Dimmer Plug from Philio Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Dimmer Plug and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.