The following is an overview of the user manual for the Z-Wave product Smart Energy Plug (PAN44_KR)from Philio. To view other Z-Wave products and manuals from Philio follow that link.
Overview
The built-in power meter can let you monitor the power consumption of your electric appliances.
The product supports an Over the Air (OTA) feature for the products firmware upgrade.
Security
As a Z-Wave Plus certified product, Smart Energy Plug supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Philio describes Smart Energy Plug as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: 1. The product has a DSK string. Key in the first five digits to initiate the SmartStart process, or scan QR code.
2. SmartStart enabled products can be added into a Z-Wave™ network by scanning the Z-Wave™ QR Code on the product, with a controller providing SmartStart inclusion.No further action is required and the SmartStart product will be added automatically to the closest network within 10 minutes of being switched on.
1. Put your Z-Wave™ controller into inclusion mode by following the instructions provided by the controller manufacturer.
2. Press the on/off button three times within two seconds to enter inclusion mode.
1. Put your Z-Wave™ controller into exclusion mode by following the instructions provided by the controller manufacturer.
2. Press the on/off button three times within two seconds to enter exclusion mode.
3. Node ID will be excluded.
Factory reset Smart Energy Plug
1. Press the on/off button three times within two seconds.
2. Within 1 second, press on/off button again last for 5 seconds.
3. Device has been reset.
Please note that this is a user manual Smart Energy Plug from Philio is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Energy Plug and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.