Smart Switch Box (PAN26-1) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Smart Switch Box (PAN26-1)from Philio. To view other Z-Wave products and manuals from Philio follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Smart Switch Box
SKU Code
PAN26-1
Description
The smart switch box is a Z-Wave TM enabled wireless device fully compatible with any Z-Wave TM enabled networks. This device is a security enabled Z-Wave Plus product that uses encrypted Z-Wave Plus messages to communicate to other security enabled Z-Wave Plus products. Z-Wave TM enabled devices displaying the Z-Wave TM logo can also be used with this device regardless of the manufacturer, and this device can also be used in other manufacturer’s Z-Wave TM enabled networks. This device must be used in conjunction with a Security Enabled Z-Wave Controller in order to fully utilize all functions. Inclusion of this unit on other manufacturer’s Wireless Controller menu allows remote operation of the unit and connected load. Remote control of Dimmer/Relay modules are possible with other manufacturer’s wireless Controller as well. PAN26 is designed to act as a repeater. Repeaters will re-transmit the RF signal to ensure that the signal is received by its intended destination by routing the signal around obstacles and radio dead spots. Its functionality and supported command classes are identical when included as a secure and non-secure device.
Version #
HW: 1 FW: 1.20:01.10 was the version certified
Certification #
ZC10-19086705
Certified
2019-08-06T22:32:56.281702
Z-Wave Version
6.81.03

Security

As a Z-Wave Plus certified product, Smart Switch Box supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

Philio describes Smart Switch Box as having the following features:

  • Firmware updatable via a compatible Z-Wave gateway
  • Loads Controlled
  • Switch Type
  • Z-Wave Scene Type
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

1.Set your Z-Wave controller into inclusion mode by following the instructions provided by the controller manufacturer.
2. Press the middle button (button ⑤) three times within 2 seconds intervals and device will enter inclusion mode.
3. Node ID is included.

1.Set your Z-Wave controller into exclusion mode by following the instructions provided by the controller manufacturer.
2. Press the middle button (button ⑤) three times within 2 seconds intervals and device will enter exclusion mode.
3. Node ID is excluded.

Factory reset Smart Switch Box

1.Press the middle button (button ⑤) four times and hold the button on the 4th time for about 3~10 seconds, then release button.
2.IDs will get excluded and all settings will be reset.

Please note that this is a user manual Smart Switch Box from Philio is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Switch Box and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.