The following is an overview of the user manual for the Z-Wave product Temperature and Humidity sensor (PAT02-2B-NS)from Philio. To view other Z-Wave products and manuals from Philio follow that link.
Overview
It is the Z-Wave plus product, it support the OTA... Those newest
features of the Z-Wave technology. Z-Wave is a wireless
communication protocol designed for home automation, specifically to remotely control applications in residential and light commercial environments. The technology uses a low-power RF radio embedded or retrofitted into home electronics devices and systems, such as lighting, home access control, entertainment systems and household appliances. This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
The device adopt the Z-Wave 500 series chip, when your Z-Wave network system is all made by Z-Wave 500 series devices. The network system will have the advantages as below.
• Concurrent multi-channel support reduces external interference.
• Better RF range, improve about 10 meters in indoor.
• Support 100 Kbps transmit speed, speed up communication.
Security
As a Z-Wave Plus certified product, Temperature and Humidity sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Philio describes Temperature and Humidity sensor as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Have Z-Wave Controller entered inclusion mode.
2. Pressing the tamper key three times within 1.5
seconds to enter the inclusion mode.
3. After add successful, the device will wake to
receive the setting command from Z-Wave
Controller about 20 seconds.
1. Have Z-Wave Controller entered exclusion mode.
2. Pressing tamper key three times within 1.5 seconds
to enter the exclusion mode.
Node ID has been excluded.
When the device power on, the device will wake about 20 seconds. In
this duration, the controller can communicate with the device. Normally
the device is always sleeping to save the battery energy.
Factory reset Temperature and Humidity sensor
Notice: Use this procedure only in the event
that the primary controller is lost or
otherwise inoperable.
1. Pressing tamper key four times within 1.5 seconds
and do not release the tamper key in the 4 th
pressed, and the LED will light ON.
2. After 3 seconds the LED will turn OFF, after that
within 2 seconds, release the tamper key. If
successful, the LED will light ON one second.
Otherwise, the LED will flash once.
3. IDs are excluded and all settings will reset to
factory default.
1. Have Z-Wave Controller entered association
mode.
2. Pressing tamper key three times within 1.5 seconds
to enter the association mode.
Note: PAT02-1A-NS and PAT02-1C-NS are support 2
groups, and PAT02-1B-NS only support 1 group. The
group 1 is for receiving the report message, like
triggered event, temperature, humidity etc. The group
2 is for the light control, the device will send the “Basic
Set” command to this group. And each group support
8 nodes maximum.
Please note that this is a user manual Temperature and Humidity sensor from Philio is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Temperature and Humidity sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.