Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Valves Controller with Water Meter (PAB04-1) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Valves Controller with Water Meter (PAB04-1)from Philio. To view other Z-Wave products and manuals from Philio follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Valves Controller with Water Meter
SKU Code
PAB04-1
Description
This valves controller PAB04 is a security enabled wireless switch, based on Z-Wave Plus technology. Z-Wave Plus TM enabled devices displaying the Z-Wave Plus TM logo can also be used with it regardless of the manufacturer, and can also be used in other manufacturer’s Z-Wave TM enabled networks. Remote On/Off control of the connected valve is possible with other manufacturer’s wireless Controller. Each switch is designed to act as a repeater. Repeaters will re-transmit the RF signal to ensure that the signal is received by its intended destination by routing the signal around obstacles and radio dead spots. Because PAB04 supports Security Command Class, it can learn with Secured controller. Its functionality and supported command classes is identical when included as a secure and non-secure device.
Connect PAB04 with an external water meter which can output pulse signals. PAB04 is able to detect instance water flow and the accumulated water.
Version #
HW: 1 FW: 1.01 was the version certified
Certification #
ZC10-20026864
Certified
2020-02-21T18:06:59.557349
Z-Wave Version
6.81.03

Security

As a Z-Wave Plus certified product, Valves Controller with Water Meter supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

Philio describes Valves Controller with Water Meter as having the following features:

  • Color
  • Firmware updatable via a compatible Z-Wave gateway
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

SmartStart location

SmartStart QR code's location as follows: 1.Product has a DSK string. For example：41810-20735-05418-54177-08777-14431-45473-10737. User can find QR code and DSK string on our product package and product.
2.SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR Code on the product, with a controller providing SmartStart inclusion. No further action is required and the SmartStart product will be added automatically to the closest network within 10 minutes of being switched on in the network vicinity.

Add(Inclusion) :
1. Put your Z-Wave controller into inclusion mode by following the instructions provided by the controller manufacturer.
2. Pressing On/Off button three times within 2 seconds will enter inclusion mode.

Remove(Exclusion) :
1. Put your Z-Wave controller into exclusion mode by following the instructions provided by the controller manufacturer.
2. Pressing On/Off button three times within 2 seconds will enter exclusion mode.

Factory reset Valves Controller with Water Meter

Reset :
1. Pressing On/Off button three times within 2 seconds will enter inclusion mode.
2. Within 1 second, press On/Off button again for 5 seconds.
3. IDs are excluded.

Please note that this is a user manual Valves Controller with Water Meter from Philio is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Valves Controller with Water Meter and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.