The following is an overview of the user manual for the Z-Wave product Z-Wave 3 in 1 Multi Sensor (PST07)from Philio Technology. To view other Z-Wave products and manuals from Philio follow that link.
Overview
The product supports Over The Air(OTA) feature for the products firmware upgrade. This product can be included and operated in any Z-Wave TM network with other Z-Wave TM certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network
will act as repeaters regardless of vendor to increase reliability of the network.
The device adopt the Z-Wave TM 500 series chip, when your Z-Wave TM network system is all made by Z-Wave TM 500 series devices. The network system will have the advantages as below.
Security
As a Z-Wave Plus certified product, Z-Wave 3 in 1 Multi Sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Philio describes Z-Wave 3 in 1 Multi Sensor as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Have Z-WaveTM Controller entered inclusion mode.
2. Pressing tamper key three times within 2 seconds to enter the inclusion mode.
1. Have Z-WaveTM Controller entered exclusion mode.
2. Pressing tamper key three times within 2 seconds to enter the exclusion mode.
3. Node ID has been excluded.
If the user want to wake-up the device immediately, please remove the
front cover, and press the tamper key once. The device will wake-up 10
seconds.
Factory reset Z-Wave 3 in 1 Multi Sensor
Notice: Use this procedure only in the event
that the primary controller is lost or
otherwise inoperable.
1. Pressing button four times and keep about 5
seconds.
2. IDs are excluded and all settings will reset to
factory default.
SmartStart location
SmartStart QR code's location as follows: The DSK can be found on the your product.
Please note that this is a user manual Z-Wave 3 in 1 Multi Sensor from Philio Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave 3 in 1 Multi Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.