The following is an overview of the user manual for the Z-Wave product Z-Wave JEM-A Adapter (PAC01-3)from Philio Technology. To view other Z-Wave products and manuals from Philio follow that link.
Overview
turer’s Z-Wave TM enabled networks. Z-Wave controller can On/Off the thermostat by sending Thermostat Setback command.
PAC01 is a transceiver which is a security enabled device which based on Z-Wave Plus technology, and it is fully compatible with any Z-Wave TM enabled network. Since PAC01 supports Security Command Class, it can learn with a Secured enabled controller to fully utilize the device. Its functionality and supported
command classes is identical when included as a secure and non-secure device.
Security
As a Z-Wave Plus certified product, Z-Wave JEM-A Adapter supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Philio describes Z-Wave JEM-A Adapter as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Put your Z-Wave controller into exclusion mode by following the instructions provided by the
controller manufacturer.
2. Pressing Include button of PAC01 three times within 2 seconds will enter exclusion mode.
3. Node ID has been excluded.
Factory reset Z-Wave JEM-A Adapter
1. Pressing Include button of PAC01 three times within 2 seconds will enter inclusion mode.
2. Within 1 second, press Include button of PAC01 again for 5 seconds.
3. IDs are excluded.
SmartStart location
SmartStart QR code's location as follows: The DSK can be found on on the back of your product.
1. Put your Z-Wave controller into inclusion mode by following the instructions provided by the
controller manufacturer.
2. Pressing Include button of PAC01 three times within 2 seconds will enter inclusion mode.
Please note that this is a user manual Z-Wave JEM-A Adapter from Philio Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave JEM-A Adapter and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.