The following is an overview of the user manual for the Z-Wave product Датчика дыма (Smoke sensor) (PSG01)from Philio Technology. To view other Z-Wave products and manuals from Philio follow that link.
Overview
communication protocol designed for home automation, specifically to
remotely control applications in residential and light commercial
environments. The technology uses a low-power RF radio embedded or
retrofitted into home electronics devices and systems, such as lighting,
home access control, entertainment systems and household appliances.
Security
As a Z-Wave Plus certified product, Датчика дыма (Smoke sensor) supports Z-Wave S2 security. The following security modes are directly supported:
Features
Philio describes Датчика дыма (Smoke sensor) as having the following features:
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Have Z-Wave Controller entered inclusion mode.
2. Pressing button three times within 1.5 seconds will enter the inclusion mode.
3. After add successful, the device will wake to receive the setting command from Z-Wave Controller, about 20 seconds.
1. Have Z-Wave Controller entered exclusion mode.
2. Pressing button three times within 1.5 seconds to enter the exclusion mode. Node ID has been removed.
After the device is added to the network, it will wake-up once per day in default. When it wakes-up it will broadcast the “Wake Up Notification” message to the network, and wake-up 10 seconds to receive the setting commands.
The wake-up interval minimum setting is 30 minutes, the maximum setting is 120 hours, the interval step is 30 minutes.
If the user wants to wake-up the device immediately, please press the button once. The device will wake-up 10 seconds.
Factory reset Датчика дыма (Smoke sensor)
Notice: Use this procedure only in the event that the primary controller is lost or otherwise inoperable.
1. Pressing button four times within 1.5 seconds and do not release the button in the 4th press, the red LED will light be ON.
2. After the red LED flash 9 times, release the button within 2 seconds.
3. IDs are removed and all settings will reset to factory default.
Please note that this is a user manual Датчика дыма (Smoke sensor) from Philio Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Датчика дыма (Smoke sensor) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.