Sensor Gateway (PIX-GW100Z) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Sensor Gateway (PIX-GW100Z)from Pixela Corporation. To view other Z-Wave products and manuals from Pixela Corporation follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Sensor Gateway
SKU Code
PIX-GW100Z can provide home automation services using Z-Wave network.
Customer can control sensor device using our mobile apps or PC apps.
Version #
HW: 1 FW: 1.04:02.21:01.04:01.00 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Sensor Gateway supports Z-Wave S2 security. The following security modes are directly supported:


    Pixela Corporation describes Sensor Gateway as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Customer can include Z-Wave product using mobile apps or PC app.

    Customer can exclude Z-Wave product using mobile apps or PC app.

    Customer can enter learn mode using PC app.

    Factory reset Sensor Gateway

    Push the hardware reset button.

    ""Please use this procedure only when the network primary controller is missing or otherwise inoperable.""

    Please note that this is a user manual Sensor Gateway from Pixela Corporation is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. only warrants and is only able to support products purchased directly from us. If you have Sensor Gateway and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.