10 Year Smoke Detector and Siren (Ei600ZW) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product 10 Year Smoke Detector and Siren (Ei600ZW)from Popp. To view other Z-Wave products and manuals from Popp follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
10 Year Smoke Detector and Siren
SKU Code
Ei600ZW
Description
This products consists of a standard high-quality photo electric Smoke detector with a pluggable Z-Wave wireless interface module. The Smoke detector will also work as a stand alone product and is certified as '10 year Smoke Detector' The
smoke chamber of the detector has a stainless steel reel with antistatic plastic chamber.
A button allows on-device test of smoke chamber, electronics and battery. The device also offers a built-in self test and
an electronic smoke chamber test to avoid the use of test aerosol. A low battery warning will last for 30 days but full
function of the detector is guaranteed during this time.
The Z-Wave module allows to report the smoke and low battery alarm wirelessly to a central controller. The detector can
also be used as a wireless siren for alarm system or other applications.
Version #
HW: 1 FW: 1.00 was the version certified
Certification #
ZC10-16125370
Certified
2016-12-23T20:43:16.99223
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, 10 Year Smoke Detector and Siren supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Popp describes 10 Year Smoke Detector and Siren as having the following features:

    • Outdoor Use
    • Color
    • Battery powered using CR2 batteries
    • Battery Quantity
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    To exclude the device start the inclusion on your controller and then hit the little button on the wireless module for 1 second

    To include the device start the inclusion on your controller and then hit the little button on the wireless module for 1 second

    Factory reset 10 Year Smoke Detector and Siren

    To reset the device keep the button pushed for 10 seconds. After 5 seconds the led starts flashing and after another 5
    seconds there is a short beep signaling the successful reset back to factory defaults. Use this procedure only when the network primary controller is missing or otherwise inoperable.

    Please note that this is a user manual 10 Year Smoke Detector and Siren from Popp is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 10 Year Smoke Detector and Siren and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.