Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Strike Lock Control (012501) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Strike Lock Control (012501)from Popp. To view other Z-Wave products and manuals from Popp follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Strike Lock Control
SKU Code
012501
Description
An electric strike is an access control device used to lock and release doors. Electric strikes are installed in or on the doorframe and work in conjunction with mechanical door lock, on the principle of electronically controlling the rotation of the keeper allowing for door opening without manual retraction of the mechanical door lock. This product combines a 16 mm thick strike lock (that will fit into almost all door formats) with a Z-Wave plus empowered wireless control. The lock mechanics and the Z-Wave control are operated by a 9V block battery or an external 8-12V AC / 8-24V DC transformer. The Z-Wave control accepts commands to open or close the strike. Depending on a configuration parameter the door will be looked automatically after a certain time even if no ‘close’ command was sent. The device can be used standalone and within every conventional Intercom system controlling strike locks.
Version #
HW: 1 FW: 1.04 was the version certified
Certification #
ZC10-17035482
Certified
2017-03-14T16:20:35.953571
Z-Wave Version
6.51.09

Security

As a Z-Wave Plus certified product, Strike Lock Control supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Popp describes Strike Lock Control as having the following features:

    • Firmware updatable via a compatible Z-Wave gateway
    • Battery powered using 9V Block batteries
    • Door Lock Type
    • Battery Quantity
    • Outdoor Use
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Pressing the Z-Wave button for one second includes the device. It is not allowed to operate the device in a non-secure environment. This means that the including controller must support Secure Command Class.

    A single click on the button will exclude the device.

    Factory reset Strike Lock Control

    To do a factory reset press the Z-Wave button on the bottom of the device for at least 10 seconds. This procedure should only be used when the primary controller is missing or inoperable.

    Please note that this is a user manual Strike Lock Control from Popp is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Strike Lock Control and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.