The following is an overview of the user manual for the Z-Wave product Wall Scene Controller (POPE009303)from Popp. To view other Z-Wave products and manuals from Popp follow that link.
Overview
Control of groups of other Z-Wave devices using 'ON', 'OFF' and Dim commands. Activation of predefined scenes in Gateways or other Z-Wave devices. This device support secure communication when included by a controller that also supports secure communication.
Security
As a Z-Wave Plus certified product, Wall Scene Controller supports Z-Wave S2 security. The following security modes are directly supported:
Features
Popp describes Wall Scene Controller as having the following features:
- Battery Quantity
- Battery powered using CR2032 batteries
- Color
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Wall Scene Controller
Use this procedure only if the primary controller is missing or otherwise inoperable.
(1) Turn the device into Management Mode by keeping all four buttons pushed for 5 seconds, (2) click on Button 3, (3) keep button 4 pushed for 4 seconds.
(1) Turn the device into Management Mode by keeping all four buttons pushed for 5 seconds, (2) click on Button 2.
Re-Inclusion and Exclusion are performed by pushing button 1 in management mode. Pushing all four buttons for 5 sec. turns the device into management mode (indicated by blinking green LED).
Place your primary controller in inclusion mode by following the manufacturer's instructions, then activate inclusion on the wall controller by pressing any one of the four buttons for one second. Inclusion mode is indicated by the red/green blinking of the LEDs until the timeout occurs after 10 seconds.
Please note that this is a user manual Wall Scene Controller from Popp is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Wall Scene Controller and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.