The following is an overview of the user manual for the Z-Wave product Z-Wave Door/Window Sensor w. Gyro and external sensor (POPE700892)from Popp. To view other Z-Wave products and manuals from Popp follow that link.
As a Z-Wave Plus certified product, Z-Wave Door/Window Sensor w. Gyro and external sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Popp describes Z-Wave Door/Window Sensor w. Gyro and external sensor as having the following features:
- Supported Notification Types
- Battery Quantity
- Battery powered using 1/AA batteries
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Tripple clicking the tamper button includes (adds) the device.
Tripple clicking the tamper button excludes (removes) the device.
It supports connecting external sensor. E.g. Dry Contact Sensor, Water Sensor probes.
A single click on the tamper button will wakeup the device.
Factory reset Z-Wave Door/Window Sensor w. Gyro and external sensor
This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only be used when the primary controller is inoperable.
Once Cover is removed and tamper switch is tripped, push the tamper for 5 seconds until red LED blinks. Then release tamper and push it again for 5 seconds until LED blinks.
Please note that this is a user manual Z-Wave Door/Window Sensor w. Gyro and external sensor from Popp is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Door/Window Sensor w. Gyro and external sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.