The following is an overview of the user manual for the Z-Wave product Z-Wave Keypad (700045)from Popp. To view other Z-Wave products and manuals from Popp follow that link.
Overview
The device can operate in two different modes. The mode is chosen the way the device is included into a Z-Wave network:
(a) Stand Alone Mode. In this case the keypad acts as the primary network controller and will include other devices such as e.g. a strike lock control or a chimney. No other central controller is needed. The management of user codes is done using the keypad itself.
(b) Network Mode. The keypad is included as additional device into an exiting network. In Z-Wave terms it will then act as secondary controller. It will send commands to a central controller and is managed by this controller. In this mode the device can still directly control door locks but it can also be used to trigger scenes in a central controller.
The device is protected by a tamper switch sending out an alarm message when the enclosure is opened.
Security
As a Z-Wave Plus certified product, Z-Wave Keypad supports Z-Wave S2 security. The following security modes are directly supported:
Features
Popp describes Z-Wave Keypad as having the following features:
- Z-Wave Scene Type
- Battery Quantity
- Battery powered using AAA batteries
- Color
- Outdoor Use
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Hit the RING button
Turn into Management Mode (remove cover), hit button 1 and confirm with * (Star Key)
Turn into Management Mode (remove cover), hit button 2 and confirm with * (Star Key)
Turn into Management Mode (remove cover), hit button 4 and confirm with * (Star Key)
Factory reset Z-Wave Keypad
Turn into Management Mode (remove cover), hit button 5 and keep button * (star key) pushed for 10 seconds. This procedure should only be used when the primary controller is inoperable.
Please note that this is a user manual Z-Wave Keypad from Popp is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Keypad and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.