The following is an overview of the user manual for the Z-Wave product Z-Wave Metering Plug Smart Start (POPE700397)from Popp & Co.. To view other Z-Wave products and manuals from Popp follow that link.
Overview
Switching is controlled by the local button or wirelessly. The use of the local button and the behavior oon wireless commands can be configured using configuration parameters. Whn detached from the control of local leads the button on the device can be used to trigger scenes in a central gateway. Single click and double click are distinguished.
The device is also measuring the mains voltage supply reporting mains voltage and mains frequency. Addtionally the powr consumption of the attached load is monitored as well.
All metering values an be requested from the central controller and will be reported unsolicited if configured.
Security
As a Z-Wave Plus certified product, Z-Wave Metering Plug Smart Start supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Popp describes Z-Wave Metering Plug Smart Start as having the following features:
- Sensors
- Electric Load Type
- Outdoor Use
- Switch Load Capacity Watts
- Supported Meter Type
- IP (Ingress Protection) Rated
- Firmware updatable via a compatible Z-Wave gateway
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Z-Wave Metering Plug Smart Start
This device allows reset without any involvement of a Z-Wave controller. This procedure should only be used when the primary controller is inoperable. Push and hold the button for 10 seconds. After 5 seconds the LED on the button will blink fast.
Tripple Click the button
Tripple Click the button
Please note that this is a user manual Z-Wave Metering Plug Smart Start from Popp & Co. is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Metering Plug Smart Start and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.