The following is an overview of the user manual for the Z-Wave product Z-Wave Rain Sensor (700168)from Popp. To view other Z-Wave products and manuals from Popp follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Rain Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Popp describes Z-Wave Rain Sensor as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Sensors
- Supported Meter Type
- Color
- Battery powered using AAA batteries
- Battery Quantity
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Z-Wave Rain Sensor
Push the button inside the device for at least 10 seconds.
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Push the Z-Wave button one time. You find the Z-Wave button by removing the electronics module from the base.
Push the Z-Wave button one time. You find the Z-Wave button by removing the electronics module from the base.
Push the Z-Wave button one time. You find the Z-Wave button by removing the electronics module from the base.
Please note that this is a user manual Z-Wave Rain Sensor from Popp is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Rain Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.