The following is an overview of the user manual for the Z-Wave product Z-Wave Zerodim 2pol (1400441)from Q-light. To view other Z-Wave products and manuals from Q-light follow that link.
Overview
Features:
- breaks both phases (L and N)
- 0-99% dimming range
- 2-180W LED load
- Compatible with any Z-Wave or Z-Wave Plus Controller
- There is memorized function at power off
- OverLoad protection
- Soft start function
- SmartStart
- This device is a security enable Z-Wave Plus product that is able to use encrypted Z-Wave Plus messages to communicate to other security enable Z-Wave Plus products.
Security
As a Z-Wave Plus certified product, Z-Wave Zerodim 2pol supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Q-light describes Z-Wave Zerodim 2pol as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Neutral Wire Required
- Z-Wave Scene Type
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Z-Wave Zerodim 2pol
Resetting the Z-Wave Puck:
1. Quickly, nine times press switch S1 / S2 or Internal button. 2. Wait for the resetting process to end, which is signaled
with the LED indicator blinks 20 times. Device reset status: Turn on the light at maximum brightness.
Please use this procedure only when the network primary controller is missing or otherwise inoperable
Removing (Exclusion):
Allowing to remove the Z-Wave device from existing Z-Wave network.
1. Place the Zerodim Z-Wave 2pol within the direct range of your Z-Wave controller.
2. Identify switch rotary knob (turns the light on) .
3. Set the main controller in (security/non-security) add mode (see the controller’s manual).
4. Quickly, three times press switch rotary knob.
5. Wait for the removing process to end.
1.Association - Instructions_ZerodimZwave_2pol_English_A4,Page 2
2.Notification - Instructions_ZerodimZwave_2pol_English_A4,Page2
3.Advanced parameters - Instructions_ZerodimZwave_2pol_English_A4,Page 2
SmartStart location
SmartStart QR code's location as follows: Security 2 DSK is located on the side of the product
Instructions_ZerodimZwave_2pol_English_A4,Page 1
Classic Learn Mode:
1. Place the Zerodim Z-Wave 2pol within the direct range of your Z-Wave controller.
2. Identify switch rotary knob (turns the light on).
3. Set the main controller in (security/non-security) add mode (see the controller’s manual).
4. Quickly, three times press switch rotary knob.
5. Wait for the adding process to end.
6. Successful adding will be confirmed by the Z-Wave
controller’s message.
Please note that this is a user manual Z-Wave Zerodim 2pol from Q-light is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Zerodim 2pol and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.