The following is an overview of the user manual for the Z-Wave product IQPanel2 (QS9201-1230-840)from Qolsys Inc.. To view other Z-Wave products and manuals from Qolsys follow that link.
Overview
Security
As a Z-Wave Plus certified product, IQPanel2 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Qolsys describes IQPanel2 as having the following features:
- Sensors
- Battery Quantity
- Communications Connections
- Battery powered using Lithium Battery batteries
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Gateway Has Preferred Partners
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Swipe down to access “Settings” < Touch “Advanced Settings” < Enter code < Touch “Installation” < Touch “Devices” < Touch “Z-Wave Devices” < Touch “Add/Remove Controller”
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Swipe down to access “Settings” < Touch “Advanced Settings” < Enter code < Touch “Installation” < Touch “Devices” < Touch “Z-Wave Devices” < Touch “Add Device” < Touch “Pair” < Press pair or learn button on device < Adjust device name as needed < Select “Automation” < Click “Add” to save
Factory reset IQPanel2
Swipe down to access “Settings” < Touch “Advanced Settings” < Enter code < Touch “Installation” < Touch “Devices” < Touch “Z-Wave Devices” < Touch “Remove All Devices”
7” HD Touchscreen
5MP Panel Camera sends disarm photos to your phone
Bluetooth Touchless Disarming
S-Line encrypted sensor technology with support for up to 128 security and life safety devices
LTE and Wi-Fi Dual Path Connectivity
Built-in Glassbreak
Built-in Router creates secure private network for IP devices
Z-Wave Plus Radio with support for up to 128 Z-Wave devices
Software updates over the air
Swipe down to access “Settings” < Touch “Advanced Settings” < Enter code < Touch “Installation” < Touch “Devices” < Touch “Z-Wave Devices” < Touch “Delete failed device from panel” < Check boxes next to devices you want to delete < Touch “Delete”
Please note that this is a user manual IQPanel2 from Qolsys Inc. is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have IQPanel2 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.