The following is an overview of the user manual for the Z-Wave product Z-Wave Plug-In Dimmer (QZ2140-840)from Qolsys Inc.. To view other Z-Wave products and manuals from Qolsys follow that link.
Overview
Additional Features:
• Power 120 VAC, 60Hz, up to 300 watts
• Region US: 908.4, 916 MHz
• Works w/ most incandescent, dimmable CFL & LED lights
• Plugs into Standard AC outlet
• Remotely controls On, Off, or Dim levels
• Control lights via schedule
• LED backlit manual On/Off button
• Second wall AC outlet remains free
• Works with any certified gateway supporting Z-Wave
Security
As a Z-Wave Plus certified product, Z-Wave Plug-In Dimmer supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Qolsys describes Z-Wave Plug-In Dimmer as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Color
- Switch Load Capacity Volt-Ampere
- Switch Load Capacity Watts
- Outdoor Use
- Switch Type
- Electric Load Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Place your network controller into inclusion mode by following the controller manufacturer's instructions.
2. When the controller is ready, single click the button on the front of the IQ Dimmer. The controller should indicate that the new device was added successfully.
3. Once the IQ Dimmer has been successfully added to your home network, you can move it to the preferred location in the home
1. Place your network controller into exclusion mode by following the controller manufacturer's instructions.
2. When the controller is ready, single click the button on the front of the IQ Dimmer. The controller should indicate that the new device was removed successfully.
3. Once the IQ Dimmer has been successfully added to your home network, you can move it to the preferred location in the home
Factory reset Z-Wave Plug-In Dimmer
1. Unplug the IQ Dimmer from the AC outlet and also unplug the power plugs of the lighting from the module (if plugged in)
2. Press and hold the button on the IQ Dimmer
3. Plug the IQ Dimmer back into the AC outlet with the button pressed. After 3 seconds, release the button. If you see the button blink, that means that IQ Dimmer has been reset successfully.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Z-Wave Plug-In Dimmer from Qolsys Inc. is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Plug-In Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.