The following is an overview of the user manual for the Z-Wave product Flush On/Off Thermostat 2 (ZMNKID3)from QUBINO. To view other Z-Wave products and manuals from Qubino follow that link.
Overview
Scheduling the temperature of your home to your lifestyle.
Automatically turn the smart heating system off after leaving the home in the morning and turn it back on remotely before returning.
The temperature sensors can trigger the heating system to turn on occasionally and prevent the temperature to drop.
On/Off Thermostat 2 can significantly reduce the energy needs and save money — while keeping the house at an optimal temperature. Heating every room separately offers a maximum level of well-being while making your home more energy-efficient. The Qubino Smart Thermostat 2 enables smart zoning, which means you can turn the heating off in isolated rooms and save energy without compromising your comfort.
Security
As a Z-Wave Plus certified product, Flush On/Off Thermostat 2 supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Qubino describes Flush On/Off Thermostat 2 as having the following features:
- Electric Load Type
- Switch Type
- Thermostat HVAC Systems Supported
- Thermostat Power Source
- Color
- Switch Load Capacity Current
- Switch Load Capacity Watts
- Thermostat Modes
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: 1. Scan QR code on device label and add S2 DSK to Provisioning List in gateway (hub)
2. Connect the device to the power supply (with the temperature sensor already connected)
3. Inclusion will be initiated automatically within few seconds of connection to the power supply and the device will automatically enrol in your network (when the device is excluded and connected to the power supply it automatically enters the LEARN MODE state).
MANUAL INCLUSION
1. Enable add/remove mode on your Z-Wave gateway (hub)
2. Connect the device to the power supply (with the temperature sensor already connected*)
3. Toggle the switch connected to the I1 terminal 3 times within 3 seconds (1 click per second). The device has to get On/Off signal 3 times, meaning 3 times push of the push button or with the normal button 3 times On/Off .
4. Inclusion with the switch connected to I1 terminal is not limited by time
Z-WAVE EXCLUSION
1. Connect the device to the power supply
2. Make sure the device is within direct range of your Z-Wave gateway (hub) or use a hand-held Z-Wave remote to perform exclusion
3. Enable exclusion mode on your Z-Wave gateway (hub)
4. Toggle the switch connected to the I1 terminal 3 times within 3 seconds
5. Exclusion with the switch connected to I1 terminal is not limited by time
Factory reset Flush On/Off Thermostat 2
FACTORY RESET
1. Connect the device to the power supply
2. Within the first minute the device is connected to the power supply, toggle the switch connected to the I1 terminal 5 times within 5 seconds
Please note that this is a user manual Flush On/Off Thermostat 2 from QUBINO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Flush On/Off Thermostat 2 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.