Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Flush RGBW Dimmer Switch Color R.G.B.W (Flush RGBW Dimmer / ZMNHWD3) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Flush RGBW Dimmer Switch Color R.G.B.W (Flush RGBW Dimmer / ZMNHWD3)from QUBINO. To view other Z-Wave products and manuals from Qubino follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Flush RGBW Dimmer Switch Color R.G.B.W
SKU Code
Flush RGBW Dimmer / ZMNHWD3
Description
Qubino Flush RGBW module is used to control RGB/RGBW strips and LED strips or bulbs to create countless colour options and has 5 special scene effects. It can also control halogen lights and fans. Its extremely small size allows for easy installation behind wall sockets and switches. Controlled devices may be powered by 12 or 24 VDC. All IN and OUT terminals may be user configured for LED control or 100 kΩ signal readouts.
Version #
HW: 255 FW: 2.07 was the version certified
Certification #
ZC10-17085753
Certified
2017-08-21T19:28:38.980602
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, Flush RGBW Dimmer Switch Color R.G.B.W supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Qubino describes Flush RGBW Dimmer Switch Color R.G.B.W as having the following features:

    • Electric Load Type
    • Firmware updatable via a compatible Z-Wave gateway
    • Color
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Connect the module to the power supply
    2. Enable inclusion mode on your Z-Wave controller
    3. Press and release the S (Service) button 3 times within 2 seconds

    1. Connect the module to the power supply
    2. Make sure the module is within direct range of your Z-Wave controller or use a hand-held Z-Wave remote to perform exclusion
    3. Press and release the S (Service) button 3 times within 2 seconds
    NOTE: The module will be excluded from your network, but any custom configuration parameters will not be erased.

    Factory reset Flush RGBW Dimmer Switch Color R.G.B.W

    FACTORY RESET
    1. Connect the module to the power supply
    2. Press and hold the S (Service) button for at least 10 seconds
    NOTE: By resetting the module, all custom parameters previously set on the module will return to their default values, and owner ID will be deleted. Use this reset procedure only when the main controller is missing or otherwise inoperable.

    Please note that this is a user manual Flush RGBW Dimmer Switch Color R.G.B.W from QUBINO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Flush RGBW Dimmer Switch Color R.G.B.W and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.