The following is an overview of the user manual for the Z-Wave product Flush RGBW Dimmer (ZMNHWD1)from QUBINO. To view other Z-Wave products and manuals from Qubino follow that link.
Overview
Security
As a Z-Wave Plus certified product, Flush RGBW Dimmer supports Z-Wave S2 security. The following security modes are directly supported:
Features
Qubino describes Flush RGBW Dimmer as having the following features:
- Neutral Wire Required
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Include the R.G.B.W. color LED Dimmer intor the Z-Wave network, press service button 3 times in 2 seconds.If the device is properly include the green light will remains on.
Exclude the Flush RGBW Dimmer into Z-Wave network, press 3 times in 2 seconds.If the device is proporly excluded, the green light will blink and data will bereset to the factory default values.
Factory reset Flush RGBW Dimmer
Please note that re-including the proudct will reset the data to the default values. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Flush RGBW Dimmer from QUBINO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Flush RGBW Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.