The following is an overview of the user manual for the Z-Wave product Luxy Smart Light (ZMNHQD1)from QUBINO. To view other Z-Wave products and manuals from Qubino follow that link.
Overview
Security
As a Z-Wave Plus certified product, Luxy Smart Light supports Z-Wave S2 security. The following security modes are directly supported:
Features
Qubino describes Luxy Smart Light as having the following features:
- Color
- Neutral Wire Required
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
MANUALLY ADDING THE DEVICE TO A Z-WAVE NETWORK (MANUAL INCLUSION)
1. Enable add/remove mode on your Z-Wave gateway (hub).
2. Connect the device to the power supply.
3. Make sure the device is within direct range of your Z-Wave gateway (hub).
4. Press once on button 2 – right. One press on button 3 – down for enabling full white. When full white is enabled, press, and hold button 2 – right, between 4 and 6 seconds. After 6 seconds, the device starts flashing green (1 second ON, 0.5 second OFF). Once the device receives node ID (after 10 seconds), it stops flashing and turns full green. The procedure is always available.
12.3. Removing the device from a Z-Wave network (Exclusion)
1. Connect the device to the power supply.
2. Make sure the device is within direct range of your Z-Wave gateway (hub) or use a hand-held Z-Wave remote to perform exclusion.
3. Enable add/remove mode on your Z-Wave gateway (hub).
4. Press once on button 2 – right. One press on button 3 – down for enabling full white. When full white is enabled, press, and hold button 2 – right for 5 seconds. After 5 seconds, the device starts flashing red 1 second ON, 0.5 second OFF.
Once the device loses node ID (after 10 seconds), it stops flashing and turns full red. The procedure is always available.
NOTE1: LEARN MODE state allows the device to receive network information from the controller.
Factory reset Luxy Smart Light
12.4. Device factory reset
1. Connect the device to the power supply.
2. Press once on button 2 – right. One press on button 3 – down for enabling full white. When full white is enabled, press, and hold button 4 – left for 10 seconds. After 10 seconds, the device starts flashing blue 1 second on, 0.5 second off.
After 10 seconds the device stops flashing and turns full blue.
The procedure is always available.
ⓘ By factory resetting the device, all custom parameters previously set on the device will return to their default values, and the node ID will be deleted. Use this reset procedure only when the main gateway (hub) is missing or otherwise inoperable.
SmartStart location
SmartStart QR code's location as follows: MPORTANT: When adding the LUXY Smart Light to a Z-Wave network with a controller supporting Security 2 (S2), the PIN code of the Z-Wave Device Specific Key (DSK) is required. The unique DSK code is printed on the product label and a copy is inserted in the packaging, which must not be lost. Do not remove the DSK from the product. As a backup measure, use the label in the packaging.
Please note that this is a user manual Luxy Smart Light from QUBINO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Luxy Smart Light and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.