The following is an overview of the user manual for the Z-Wave product Smart Plug 16A (ZMNHYD1)from QUBINO. To view other Z-Wave products and manuals from Qubino follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smart Plug 16A supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Qubino describes Smart Plug 16A as having the following features:
- IP (Ingress Protection) Rated
- Outdoor Use
- Color
- Supported Meter Type
- Firmware updatable via a compatible Z-Wave gateway
- Supported Notification Types
- Switch Load Capacity Current
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
REMOVAL FROM A Z-WAVE NETWORK (Z-WAVE EXCLUSION)
1. Connect the device to the power supply
2. Make sure the device is within direct range of your Z-Wave gateway (hub) or use a hand-held Z-Wave remote to perform exclusion
3. Enable add/remove mode on your Z-Wave gateway (hub)
4. Press and hold the Service button S from 2 to 6 seconds (with holding the S button for the interval between 2 and 6 seconds you put the device in EXCLUSION MODE)
5. The device will be removed from your network, but any custom configuration parameters will not be erased
AUTOMATICALLY ADDING THE DEVICE TO A Z-WAVE NETWORK (AUTO INCLUSION)
1. Enable add/remove mode on your Z-Wave gateway (hub)
2. Automatic selection of secure/unsecure inclusion
3. The device can be automatically added to a Z-Wave network during the first 2 minutes
4. Connect the device to the power supply
5. Auto-inclusion will be initiated within 5 seconds of connection to the power supply and the device will automatically enrol in your network (when the device is excluded and connected to the power supply it automatically enters the INCLUSION MODE state.)
Factory reset Smart Plug 16A
FACTORY RESET
• The reset is only possible the first minute after the power on
• Press and hold the service button S more than 6 seconds
• The device will be removed from your network and the led will start blinking. The device is now in its factory default state.
• When the S button is held more than 6 seconds after the first minute is passed, the relay should not react!
By resetting the device, all custom parameters previously set on the device will return to their default values, and the owner ID will be deleted. Use this reset procedure only when the main gateway (hub) is missing or otherwise inoperable.
1. Qubino Smart Plug 16A supports S2 Authenticated security.
2. Smart Plug 16A can automatically turn devices/lights on or off after a set period of time. Independent of other scenes and gateway (hub) commands.
Please note that this is a user manual Smart Plug 16A from QUBINO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Plug 16A and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.