The following is an overview of the user manual for the Z-Wave product CT100 Plus (CT100)from Radio Thermostat Company of America. To view other Z-Wave products and manuals from Radio Thermostat Company of America follow that link.
Overview
Security
As a Z-Wave Plus certified product, CT100 Plus supports Z-Wave S2 security. The following security modes are directly supported:
Features
Radio Thermostat Company of America describes CT100 Plus as having the following features:
- Battery Quantity
- Battery powered using AA batteries
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Sensors
- Thermostat HVAC Systems Supported
- Thermostat Modes
- Thermostat Power Source
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
From the CT100’s Menu screen, touch MATE under the radio icon. The Network Include screen displays a large r1. Touch MATE again. This initiates the network inclusion process. The MATE icon and the status indicator LEDs will blink. When the CT100 has successfully included into a Z-Wave network, the
MATE icon is replaced by the LINK icon under the radio tower.
Same process as inclusion. Similarly, when you are trying to exclude from a network, the LINK icon disappears when the node has successfully excluded the network.
When included into a Z-Wave network on battery power, this device is a FLiRS device. The Thermostat will wake up for communication when it receives a valid Z-Wave beam.
Factory reset CT100 Plus
Switch the thermostat to Off Mode. Press and hold the lower left corner of touch screen for five (5) seconds. The thermostat then resets itself, displays its current firmware version, and restarts in Off Mode. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual CT100 Plus from Radio Thermostat Company of America is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have CT100 Plus and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.