The following is an overview of the user manual for the Z-Wave product Ct110 (CT110)from Radio Thermostat Company of America. To view other Z-Wave products and manuals from Radio Thermostat Company of America follow that link.
Overview
Security
As a Z-Wave Plus certified product, Ct110 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Radio Thermostat Company of America describes Ct110 as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
When included into a Z-Wave network on battery power, this device is a FLiRS device. The Thermostat will wake up for communication when it receives a valid Z-Wave beam.
Press and hold the network button for 5 seconds. The thermostat must be in OFF mode.
Press and hold the network button for 5 seconds. The thermostat must be in OFF mode.
Factory reset Ct110
Press the network button 5 times to factory reset the thermostat (will clear the network information). The thermostat must be in OFF mode. Use the reset procedure only when the primary controller is missing or inoperable.
Please note that this is a user manual Ct110 from Radio Thermostat Company of America is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Ct110 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.