The following is an overview of the user manual for the Z-Wave product RE.GUARD Water Sensor (14573101001)from REHAU. To view other Z-Wave products and manuals from REHAU follow that link.
Overview
battery. It is used for detecting water overflowing. It can communicate with an associated Z-Wave device, such as RE.GUARD Water Control, Siren, Smart Switch, etc.
The features:
1) Z-Wave Plus certified for wide compatibility (500 serials product).
2) Supports security 0 and security 2 protected mode with AES-128 encryption.
3) Contains an extension water detecting probe.
4) Temperature measurement.
5) The battery life is up to 1 year.
6) Support low battery alarm function.
7) Support firmware OTA.
Security
As a Z-Wave Plus certified product, RE.GUARD Water Sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
REHAU describes RE.GUARD Water Sensor as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Sensors
- Supported Notification Types
- Battery Quantity
- Battery powered using ER14250 batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset RE.GUARD Water Sensor
1)Power on the device
2) Press and hold the Z button for more than 20 seconds
3)If holding time more than 20 seconds, the LED indicator will keep on for 2 seconds, which means resetting is complete.
The reset feature works only when the device has been included into a Z-Wave network.
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Press and hold the Z button for more than 3 seconds and release.
1) Open the cover.
2) Place the device within the direct range of your Z-Wave controller.
3) Set the main controller remove mode (see the controller’s manual).
4) Triple click the Z-button quickly, the LED indicator should blink fast.
5) Wait for the removing process to end.
6) Successful adding will be confirmed by the Z-Wave controller’s message.
1) Open the cover.
2) Place the device within the direct range of your Z-Wave controller.
3) Set the main controller in add mode (see the controller’s manual).
4) Click the Z-button once or triple click the Z-button quickly, the LED indicator should blink fast.
5) Wait for the adding process to end.
6) Successful adding will be confirmed by the Z-Wave controller’s message.
Please note that this is a user manual RE.GUARD Water Sensor from REHAU is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have RE.GUARD Water Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.