AC Master Lite (ZXT-510EU) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product AC Master Lite (ZXT-510EU)from Remotec. To view other Z-Wave products and manuals from Remotec follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
AC Master Lite
SKU Code
ZXT-510EU
Description
ZXT-510, AC Master Lite, is a Z-Wave plus compliant Z-Wave-to-IR Bridge to control split air conditioner by receiving Z-Wave command and translating to Infrared command. With its comprehensive built-In and cloud-stored IR database (library). ZXT-510 can control different brands and models of air conditioners worldwide.
ZXT-510 is a security enabled Z-Wave plus device. A security Enabled Z-Wave Plus Controller must be used in order to fully utilize the product.
ZXT-510 is a Z-Wave slave device, it depends on gateway to setup particular AC brand with correct IR code. Different gateway has different user interface for setup.
Version #
HW: 0 FW: 1.04:01.07:182.03 was the version certified
Certification #
ZC10-18116315
Certified
2018-11-20T08:03:54.292502
Z-Wave Version
6.61.00

Security

As a Z-Wave Plus certified product, AC Master Lite supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Remotec describes AC Master Lite as having the following features:

    • Thermostat Modes
    • Color
    • Thermostat HVAC Systems Supported
    • Firmware updatable via a compatible Z-Wave gateway
    • Sensors
    • Battery powered using CR123A batteries
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1 Refer to your primary controller to enter into Exclusion Mode
    2 When it is prompted to enter it, please triple click the “PROG” button within 1 second.
    3. Green Indicator flashes TWICE then stay off

    Factory reset AC Master Lite

    Press and Hold ""PROG"" button for 3 seconds on AC Master Lite, the Green Indicator will light up. DO NOT Release the ""PROG"" Button until Green Indicator flashes TWICE.
    Remark : Please use this procedure only when the network primary controller is missing or otherwise incoperable.

    1 Refer to your primary controller to enter into Inclusion Mode
    2 When it is prompted to enter it, please triple click the “PROG” button within 1 second.
    3. Green Indicator flashes TWICE then stay off

    Press the ""PROG"" button to wakeup the unit

    Please note that this is a user manual AC Master Lite from Remotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have AC Master Lite and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.